In the case of a power cut, you see a ‘Alert! Enter Code’ message on your Honeywell Galaxy alarm keypad – indicating that you have some kind of fault on your alarm system (but not specifying what the problem is). If you’ve had a power cut in your property and you have no power to your ADT Honeywell Galaxy alarm system, then this will affect your alarm – and if you have an old battery, make cause you system to go off / ring.
If it was powered down successfully, then the keypad or display screen will be completely blank.ADT Honeywell Galaxy Alarm Power failure problem Check the panel's display screen or keypad to make sure that the system is powered down. You can then gently pull it out from the wall outlet.ģ. If this is the case, you will need a screwdriver to unscrew the transformer. Often, the transformer will be screwed into the wall outlet. You must unplug this transformer to power down your Honeywell System. There will be a plug-in transformer that runs from the security panel to the wall outlet. Disconnect the wires from both of these terminals to disconnect the battery.Ģ. There will be a positive terminal and a negative terminal on the battery. On a Honeywell VISTA Series panel, the backup battery is usually a large black box found inside the system's beige metal cabinet. In this case, simply unplug the battery from the circuit board to disconnect the battery. The battery on a wireless Honeywell Panel will typically be plugged into the circuit board. On a wireless all-in-one panel, you may have to remove its back cover to access the battery. The location of this battery varies between different systems. Every Honeywell Control Panel has a backup battery. To power off a Honeywell Alarm System, complete the following steps, in this order:ġ. You can confirm that the system has powered on by checking its display screen or keypad. It will usually take a few minutes for this process to complete. The panel should automatically turn back on. When you want to turn your system back on, first plug-in the transformer. Once both are disconnected, the panel will shut down. You should disconnect the backup battery before unplugging the transformer. These include its backup battery and its plug-in transformer. You can turn off your Honeywell Alarm System by disconnecting both of its power supplies.
0 kommentar(er)
